Q1.Is it possible to use other brand but same power lamp in our 7R plus?
No, the light bulb and the ballast must be matched and adjusted before sent out from the factory and cannot use other brand to replace.
Q2. The light does not respond when turned onA1.Check the fuse inside the light A2.Check whether the switching power supply has output voltage.
A3.Check whether the circuit board is working normally (indicator light): red is the powe-r working indicator.
Q3. After starting up and working for a period of time, the light automatically resetsA1.The output of the switching power supply is unstable.
A2.The wire in the line is loose or the pressure line is not pressed tightly, resulting in poor contact and automatic reset.
Q4.Bulbs are automatically defoamedA1.After the bulb goes out, it will automatically turn on again after a period of time. Check whether the cooling system is working properly, if the cooling system fails, it will automatically light up. A2.After the bulb is defoamed, the bulb cannot be automatically turned on: the problem of the bulb itself, the surface of the bulb sphere is whitened, and the interior is black, and the phenomenon of defoaming will also occur after a period of bright bulbs (the life of the bulb ends). A3.The lamp will also have automatic bubble protection when there is no control signal for a long time, and it will automatically light up after the signal is turned on.
Q5. No display on the display panelA1.Damaged display panel. A2.Whether the seven-digit cable connected to the display panel is loose or damaged.
Q6.The light bulb is on, the motor reset is normal, but it is not controlledA1.Check connection signal (DMX).
A2.Check the lamp address code.
Q7.It can brighten the bubble and can be controlled, but it is not white light after resetA1.Whether the distance between the Hall element and the magnet is between 2-3mm. A2.Whether the lamp is zero adjusted.
Q8.Motor shaking or out of stepA1.Whether the motor is short-circuited. A2.Damaged motherboard. A3.Whether the fixing screws of each pattern wheel and color wheel are tightened. 4.Inaccurate positioning between the Hall element and the magnet.
Q9.The X and Y axes are out of step and cannot be positionedA1.There is too much dust on the optical lotus, so the infrared light cannot be controlled in place A2.Is the drive belt fixing screw tight? A3.The optical lotus plate is broken, and the distance between the optical lotus plate and the optical lotus is not properly adjusted (when removing, the lotus root should be in the middle of the optical lotus plate, and there should be no scratches, bumps, and rubs) A4.Whether the stepper motor mounting screws are too loose or too tight A5.Whether the belt is broken
you can also watch video,link https://forum.asmslit.net/thread-10-1-1.html
if you have any other questions,please repost the question,but not reply in this thread.
| 
