|
|
Edited by hunter at Dec 8,2022 00:28
In the process of using the moving head light, it should be operated according to the purchased product manual. If some details are not fulfilled or if you install and use at will without knowing the operating specifications, then it is very likely that there will be problems in use due to improper operation of a certain link, so when operating the moving head beam computer light During the process, the following issues should be paid attention to:
LED Wash Light
1. How to solve the problem of no response or light bulb not working
If you find that there is no response when the moving head beam computer light is turned on, it may be because the power supply is not connected properly, so first check the working lines such as power lines and signal lines and the working voltage and voltage, and then reconnect them. But if the work light is not on, then you should check whether the bulb is loose or it may be that the bulb has broken, and the power switch should also be checked, and then deal with it in time.
2. How to solve the problem of automatic light bulb extinguishing
If the bulb turns off automatically and turns on automatically after a period of time, it is likely that the temperature is too high and the working temperature cannot be effectively lowered in time to trigger the automatic protection of the system. Therefore, you should first check whether the heat dissipation system (especially the cooling fan) can effectively dissipate heat, otherwise it may cause this phenomenon to happen. If the light bulb does not turn on automatically after it is turned off, it may be because the light bulb itself is broken. It can be replaced directly.
3. How to solve the problem of starting up the fuse or power tripping
If such a phenomenon occurs during the process of turning on the moving head beam computer light, it is obviously caused by a short circuit or an excessive current. Therefore, manufacturers of moving head beam lights will emphasize that in order to better solve this problem, you should check whether the lamp is connected to the ground, whether the high voltage inside the lamp is short-circuited to the ground, and then repair it in time after finding the problem. can be used again.
The above are several problems that need to be paid attention to in the operation of the moving head beam light. In addition, you may encounter problems such as insufficient brightness of the bulb. The better manufacturers of moving head beam lights in the industry will remind customers that when encountering this situation, they should first check whether the supplied working voltage is too low or the trigger is faulty, and it may also be a problem with the electronic rectifier. Every link should be carefully checked before processing.
|
|
